ID SR195 ELECTRIC PRESSURE WASHER MACHINE [G-240V] - 21769

Yes. The ID SR195 Electric Pressure Washer operates on 220-240V AC at 50/60 Hz and comes with a Type G British 3-Pin plug, which is the standard socket type used across the UAE, Saudi Arabia, Qatar, and other GCC countries. It is fully plug-and-play compatible with no adapters needed.

Yes, the ID SR195 carries CE certification following independent machine testing. CE marking confirms that the product meets the European Union's safety, health, and environmental protection standards. For you as a buyer, this means the machine has been independently verified to be safe for domestic and professional use, giving you confidence in its electrical safety and build quality.

The SR195 comes as a complete ready-to-use kit. The package includes the main pressure washer machine, a high-pressure gun, a 5-metre high-pressure pipe, an inlet pipe, a quick connector, a filter net, a user guide book, and 10 sachets of special car shampoo — so you can begin cleaning immediately after unboxing with no additional accessories required.

The SR195 is versatile enough to handle a wide range of surfaces. It is well-suited for cleaning driveways, patios, concrete floors, garden paths, building walls, fences, outdoor furniture, and vehicles including cars, SUVs, and motorcycles. Its 8 bar working pressure and 7.5 L/min flow rate make it effective at removing mud, grease, algae, bird droppings, and general grime.

Double insulation means the SR195 is designed so that all internal electrical components — including the motor and wiring — are completely isolated from the outer casing of the machine. This means even if the outer shell is wet or damaged, there is no path for electrical current to reach the user. It is a critical safety feature for any machine used outdoors in wet conditions and is a requirement for CE-certified electrical equipment.

The SR195 operates at a maximum working pressure of 8 bar and a flow rate of 7.5 litres per minute. The pressure determines how forcefully water hits the surface — at 8 bar, it is strong enough to dislodge stubborn dirt, oil, and biological growth. The flow rate controls how much water is delivered per minute, balancing cleaning speed with water efficiency. Together, these specifications make the SR195 effective for both light maintenance washes and intensive deep-cleaning tasks.

If the SR195 is running but not building pressure, start by checking the filter net included in the kit — a blocked inlet filter is one of the most common causes of pressure loss. Ensure the inlet pipe is fully connected and the water supply is turned on with adequate flow. Also confirm the quick connector is properly seated on the high-pressure gun. If the issue persists after checking these points, refer to the included guide book or contact our support team.

The SR195 is designed to be connected to a standard tap or water supply line via the included inlet pipe. Using it with a gravity-fed tank or bucket is generally not recommended unless the tank can provide sufficient and consistent water pressure and flow to the inlet. Running the pump dry or with insufficient water supply can cause damage to the pump and void the warranty. Always ensure a steady water source is connected before operating the machine.

Leaks at the hose connection are usually caused by an improperly seated quick connector or a worn seal. First, disconnect the high-pressure pipe and re-attach it firmly, ensuring the quick connector clicks securely into place. Inspect the connector and pipe ends for any visible damage or debris. If the leak continues, check whether the connector O-ring or seal is intact. Replacement seals are standard fittings available at most hardware stores. Do not operate the machine with a leaking connection as it may reduce pressure and cause water damage.