ID DS150 ELECTRIC DISC SANDER MACHINE [G-240V] - 21682

Yes. The ID DS150 Electric Disc Sander is a versatile tool designed for both metalworking and woodworking applications. Its 405W motor and 4,700 RPM speed provide the power needed for aggressive material removal on metal surfaces such as deburring and weld seam blending, as well as wood shaping and stock removal. Simply select the appropriate abrasive disc grit for your material and task.

The ID DS150 comes fitted with a Type G (British 3-Pin) plug, which is the standard plug type used in the UAE. It operates on 220–240V AC at 50/60Hz, fully compatible with the UAE mains supply. No adapter or converter is required — simply plug in and get to work.

The DS150 comes as a complete, ready-to-use package. In the box you will find the disc sander machine itself, a side handle for improved grip and control during operation, an auto-stop carbon brush set (1 pair) that protects the motor by automatically cutting power when the brushes wear out, and a guide book to help you set up and operate the machine safely and correctly.

The DS150 accepts abrasive discs up to 150mm (6 inches) in diameter using a standard M8 spindle thread. This is one of the most common disc sizes available in the market, meaning replacement and upgrade discs in a wide range of grits — from coarse for rapid removal to fine for surface finishing — are widely available at hardware and power tool stores.

The spindle lock is a built-in mechanism that holds the spindle stationary when engaged, allowing you to loosen or tighten the disc with one hand without the spindle rotating. This makes disc changes faster, safer, and more convenient — particularly useful on a busy job site or in a workshop where you frequently switch between different grit discs for different stages of a project.

Double insulation is a safety design standard where the tool's internal electrical components are separated from the outer casing by two independent layers of insulation. This means that even if the primary insulation fails, the secondary layer prevents any live electrical current from reaching the outer body of the tool. For users, this means a significantly reduced risk of electric shock, making the DS150 safer to use in workshop and construction environments where contact with moisture or conductive surfaces is possible.

If the DS150 stops unexpectedly during use, the most likely cause is the auto-stop carbon brushes reaching the end of their service life. This is a built-in protective feature — when the carbon brushes wear down to a safe minimum, they automatically cut power to the motor to prevent internal damage. The solution is straightforward: replace the carbon brush set. A spare pair is included in the box. Refer to the guide book for step-by-step replacement instructions. If the machine still does not operate after replacing the brushes, contact your supplier for further support.

Difficulty removing the disc is usually caused by not fully engaging the spindle lock before attempting to loosen the disc. Ensure the machine is switched off and unplugged before any disc change. Press and hold the spindle lock button firmly to immobilise the spindle, then use the appropriate wrench on the M8 spindle thread to loosen the disc. If the disc has become stuck due to heat or debris build-up, allow the machine to cool completely before attempting removal, and clean the spindle thread regularly to prevent seizing.

Excessive vibration during operation is most commonly caused by an unbalanced or incorrectly fitted abrasive disc. Ensure the disc is centred correctly on the spindle and that the retaining nut is tightened securely with the spindle lock engaged. Also check that the disc itself is not damaged, warped, or unevenly worn — a damaged disc should be replaced immediately. Using the side handle included with the machine will also help you maintain better control and reduce the perceived vibration during heavy-duty tasks.